Sökresultat

Self-assembly of block copolymers (BCPs) provides an attractive nanolithography approach, which looks especially promising for fabrication of regular structures with characteristic sizes below 10 nm. Nevertheless, directed self-assembly (DSA) and pattern transfer for BCPs with such small features remain to be a challenge. Here we demonstrate DSA of the maltoheptaose-block-polystyrene (MH1,2k-b-PS4

Low-frequency noise measurements were performed on high-performance InGaAs nanowire MOSFETs. 1/f noise measurements show number fluctuations, rather than mobility fluctuations, as the dominant noise source. The minimum equivalent input gate voltage noise reported here is 80 μm2μV2/Hz, among the lowest values for III-V FETs, and showing the feasibility of a high-quality, low trap density, high-k ga

Radial GaInP/AlGaInP nanowire array light-emitting diodes (LEDs) are promising candidates for novel high-efficiency solid state lighting due to their potentially large strain-free active emission volumes compared to planar LEDs. Moreover, by proper tuning of the diameter of the nanowires, the fraction of emitted light extracted can be significantly enhanced compared to that of planar LEDs. Reports

The increased demand for high purity nanoparticles (NPs) of defined geometry necessitates the continuous development of generation routes. One of the most promising physical techniques for producing metal, semiconductor or alloy NPs in the gas phase is spark discharge NP generation. The technique has a great potential for up-scaling without altering the particles. Despite the simplicity of the set

Semiconductor nanowire (NW) solar cells with a single p-n junction have exhibited efficiency comparable to that of their planar counterparts with a substantial reduction in material consumption. Tandem geometry is a path toward the fabrication of devices with even higher efficiencies, for which a key step is the fabrication of tunnel (Esaki) diodes within NWs with the correct diameter, pitch, and

Butyric acid has been shown to have suppressive effects on inflammation and diseases related to the intestinal tract. The aim of the present study was to investigate whether supplementation of two glycerol esters, monobutyrin (MB) and tributyrin (TB), would reach the hindgut of rats, thus having an effect on the caecal profile of SCFA, microbiota composition and some risk markers associated with c

African trypanosomes are responsible for significant levels of disease in both humans and animals. The protozoan parasites are free-living flagellates, usually transmitted by arthropod vectors, including the tsetse fly. In the mammalian host they live in the bloodstream and, in the case of human-infectious species, later invade the central nervous system. Diagnosis of the disease requires the posi

HCCI (Homogeneous Charge Compression Ignition) is a very control-intensive combustion concept which has been studied for over a decade because of its favorable combination of high efficiency and low emissions. Various optimal control methods have been applied to HCCI and this chapter gives an overview of them. Optimal control of HCCI can be divided into model based and non-model based where MPC is

Partially premixed combustion is a compression ignited combustion strategy where high exhaust gas recirculation (EGR) levels in combination with early or late injection timing result in a prolonged ignition delay yielding a more premixed charge than with conventional diesel combustion. With this concept it is possible to get low smoke and NOx emissions simultaneously. Accurate control of injection

Previous research carried out by the authors described the role of dual-fuel combustion efficiency on overall engine efficiency at high diesel substitution ratio. At low loads, high diesel substitution ratios result in excessive total unburned hydrocarbon emissions due to bulk flame quenching, and consequently lower substitution ratios in combination with intake air heating, throttling and increas

The effects of fuel properties on the performance and emissions of an engine running in partially premixed combustion mode were investigated using nine test fuels developed in the gasoline boiling point range. The fuels covered a broad range of ignition quality and fuel chemistry.The fuels were characterized by performing a load sweep between 1 and 12 bar gross IMEP at 1000 and 1300 rpm. A heavy d

In Sweden, leishmaniasis is an imported disease and its epidemiology and incidence were not known until now. We conducted a retrospective, nationwide, epidemiological study from 1993 to 2016. Probable cases were patients with leishmaniasis diagnoses reported to the Swedish Patient registry, collecting data on admitted patients in Swedish healthcare since 1993 and out-patient visits since 2001. Con

Background: Controversy exists as to the health effects of exposure to asphalt and crumb rubber modified (CRM) asphalt, which contains recycled rubber tyres. Objective: To assess exposures and effects on airway symptoms, lung function and inflammation biomarkers in conventional and CRM asphalt road pavers. Methods: 116 conventional asphalt workers, 51 CRM asphalt workers and 100 controls were inve

Objective: Additional and comorbid diagnoses are common among suicide victims with major depressive disorder (MDD) and have been shown to increase the suicide risk. The aim of the present study was first, to investigate whether patients with severe depression/melancholia who had died by suicide showed more additional psychiatric disorders than a matched control group. Second, general rates of como

Partially premixed combustion aims to reduce NOx and particulate matter emission without fuel consumption penalty. Low temperature reactions are important for the partially premixed combustion. In the current study, a self-adaptive strategy is introduced to predict the motoring pressure by means of an equivalent isentropic index. The start of the low temperature reactions is detected when the pres