Filtyp
Protection of systems with series compensated lines is considered to be one of the most difficult tasks for relay manufacturers and utility engineers. Protection and control of surrounding circuit elements, particularly transmission line protection, needs to be adapted to the variations introduced by these devices. Fixed series capacitors and thyristor controlled devices introduce harmonics and no
We have investigated the possibility of using a curved dipole antenna inside the mouth for the tongue controlled wireless devices in 2.45GHz ISM band. These devices can be interfaced with the wheelchair or the computer used by the paraplegic patients. Two antenna placement positions have been investigated: in front of the teeth and behind the teeth. The investigations were done through the FDTD si
The physical bounds for antennas above a ground plane is analyzed in this paper. Optimal antenna G/Q ratio and Q factor are calculated using convex optimization from stored electric and magnetic energy matrices, obtained from a method of moments solver. Physical bounds for a patch antenna with different heights above a ground plane are investigated. Results are verified using commercially availabl
Rapport i Högskolepedagogisk introduktionskurs / Report written in course "Introduction to Teaching and Learning in Higher Education". Undervisningen i en befintlig laboration i våglära relateras till pedagogisk litteratur, kursens mål och egna erfarenheter för att formulera ett förslag på betygsgrunder specifikt för denna laborations rapport. Förhoppningen är att öka jämförbarheten mellan betyg f
Adaptive techniques such as gain scheduling, automatic tuning and continuous adaptation have been used in industrial single-loop controllers for about ten years. This paper gives a survey of the different adaptive techniques, the underlying process models and control designs. An overview of industrial products is also presented, which includes a fairly detailed investigation of four different adap
A search for the lepton flavour violating processes ep→μX and ep→τX is performed with the H1 experiment at HERA. Final states with a muon or tau and a hadronic jet are searched for in a data sample corresponding to an integrated luminosity of 66.5 pb-1 for e+p collisions and 13.7 pb-1 for e-p collisions at a centre-of-mass energy of 319 GeV. No evidence for lepton flavour violation is found. Limit
[abstract missing]
An explanation is given for the paradoxical fact that, at low signal-to-noise ratios, the systematic feedback encoder results in fewer decoding bit errors than does a nonsystematic feedforward encoder for the same code. The analysis identifies a new code property, the d-distance weight density of the code. For a given d-distance weight density, the decoding bit error probability depends on the num
Turbines operating in wind farms are coupled by the wind flow. This coupling results in limited power production and increased fatigue loads on turbines operating in the wake of other turbines. To operate wind farms cost effectively, it is important to understand and address these effects. In this paper, we derive a stationary model for turbine interaction. The model has a simple intuitive structu
This paper focuses on the design and the evaluation of a three-phase permanent magnet synchronous machine (PMSM) that stator core is made of Soft Magnetic Mouldable Composite – SM2C. A radial flux PM machine with modular winding is designed for a high-speed low-voltage automotive application. Manufacturability and a high fill factor of the winding are vital for a low permeability stator core in or
